文章摘要
基于密度法的多层约束阻尼结构拓扑优化设计
Topology Optimization Design of Multi-layer Constrained Damping Structure Based on Density Method
投稿时间:2025-09-07  
DOI:10.16018/j.cnki.cn32-1650/n.202504004
中文关键词: 减振  多层约束阻尼  材料插值模型
英文关键词: vibration reduction  multi-layer constrained damping  material interpolation model
基金项目:
作者单位
张振 武汉纺织大学机械工程与自动化学院,湖北武汉 430200 
吴紫俊 武汉纺织大学湖北省数字化纺织装备重点实验室,湖北武汉 430200 
摘要点击次数: 42
全文下载次数: 22
中文摘要:
      针对高速织机等大幅面结构的抑振降噪问题,通过约束阻尼结构的本构关系,探索多阻尼层、约束层之间的数学模型;基于有限元方法建立多层约束阻尼板的动力学模型,利用拓扑优化理论,分析动力学模型中力学矩阵与单元密度设计变量间的耦合关系,建立多层约束阻尼板材料插值模型;基于密度法搭建多层约束阻尼板结构优化设计框架,并以约束阻尼材料的表面敷设总量为约束,以模态损耗因子的倒数最小化为优化目标,推导优化设计变量的灵敏度;最后以悬臂梁与两端固定梁为例对所提方法的有效性进行验证,结果表明:随着阻尼材料体积分数增加,模态损耗因子显著提高;在50%的体积约束下,两端固定梁的损耗因子从0.262提升至0.349,悬臂梁的损耗因子从0.138提升至0.215。
英文摘要:
      To address the vibration suppression and noise reduction in large-scale structures such as high-speed looms, this study explores the mathematical model for multiple damping layers and constraining layers through the constitutive relationship of constrained damping structures. The dynamic model of the multi-layer constrained damping plate was then developed using the finite element method. By applying topology optimization theory, the coupling relationship between the mechanical matrix and the element density design variables in the dynamic model was analyzed, leading to the establishment of a material interpolation model for the multi-layer constrained damping plate. A structural optimization design framework for the multi-layer constrained damping plate structure was constructed based on the density method, with the optimization objective set to minimize the reciprocal of the modal loss factor, subject to a constraint on the total volume of the damping material. The sensitivity of the design variables was derived analytically. Finally, the effectiveness of the proposed method was verified using a cantilever beam and the fixed-fixed beam as examples. The results showed that the modal loss factor increased significantly with the increase of the damping material volume fraction. Under a 50% volume constraint, the loss factor of the fixed-fixed beam increased from 0.262 to 0.349, and that of the cantilever beam increased from 0.138 to 0.215.
查看全文   查看/发表评论  下载PDF阅读器
关闭